To Next PageTo Next PageWhat to do if no water drain out of the Indesit DIF 14B1 Dishwasher?
If your Indesit dishwasher is not draining water, it might be because the wash cycle hasn't finished yet. Check if the water drain hose is bent. Also, inspect the drain duct and filter for clogs. Finally, verify the height of the drain hose.
How to fix Indesit DIF 14B1 Dishwasher that does not start?
If your Indesit Dishwasher won't start or respond to commands, try these steps: * Turn the dishwasher off using the ON/OFF button, wait about a minute, and then turn it back on and reset the program. * Ensure the dishwasher is properly plugged into the power outlet. * Make sure the dishwasher door is fully closed and latched.
Why is my Indesit Dishwasher not cleaning properly?
If your Indesit Dishwasher leaves crockery unclean, consider the following: * Avoid overloading the racks. * Arrange the crockery properly to ensure water reaches all surfaces. * Check that the sprayer arms can rotate freely. * Select a more intensive wash cycle if the current one is too gentle. * Ensure you are using the correct amount of suitable detergent, as excessive foam can hinder cleaning. * Verify that the lid on the rinse aid compartment is correctly closed. * Clean a dirty or blocked filter. * Check and replenish the refined salt level. * Also, try turning off the appliance using the ON/OFF button. Turn off the water tap to avoid any flooding and unplug the appliance. Ensure that the water inlet filter is not blocked by impurities.
What to do if Indesit Dishwasher won't drain?
If water isn't draining from your Indesit Dishwasher, here's what to check: * Wait until the dishwasher cycle has completely finished. * Inspect the water drain hose to ensure it is not bent. * Check for any blockages in the drain duct. * Clean the filter if it's clogged with food residues.
Why Indesit DIF 14B1 is not drying?
If your Indesit Dishwasher isn't drying the crockery well, consider these points: * Make sure you've selected a wash cycle that includes a drying cycle. * Check if the rinse aid has been used up or if the dosage is too low. * Verify that the rinse aid setting is appropriate. * Note that crockery made from non-stick material or plastic may not dry as effectively.
What to do if my Indesit Dishwasher won’t load water and is blocked with flashing lights?
If your Indesit Dishwasher won’t load water and shows flashing lights, it could be due to several reasons. First, ensure that there is water in the mains supply and that the tap is turned on. Check if the water inlet hose is bent. Also, the filters or the drain duct might be clogged and need cleaning. After checking and cleaning these components, try switching the dishwasher on and off before starting a new wash cycle.
Why are my dishes streaked after using my Indesit DIF 14B1?
If your Indesit dishwasher leaves streaks or a bluish tinge on dishes and glasses, the rinse aid dosage is likely too high.
Why Indesit DIF 14B1 is not taking water?
If your Indesit Dishwasher isn't taking in water and the tap shut-off alarm is activated, check these: * Confirm that there is water in the mains supply. * Ensure the water inlet hose isn't bent. * Try turning on the tap; the appliance should start after a few minutes. * If the appliance lock has been activated due to inaction after beeps, address this. * Alternatively, switch off the machine using the ON/OFF button, turn on the tap, and switch the machine back on after a few seconds. Then, reprogram the appliance and restart the wash cycle.
What to do if Indesit DIF 14B1 won’t load water and is blocked with flashing lights?
If your Indesit dishwasher won’t load water and the lights are flashing, check the following: ensure that there is water in the mains supply and that the tap is turned on. Make sure the water inlet hose isn't bent. Clean any clogged filters or drain ducts. After checking and cleaning, try switching the dishwasher off and on again and starting a new wash cycle. If the issue continues, turn off the water tap, remove the plug, and seek professional assistance.
How to fix an Indesit Dishwasher that does not start or cannot be controlled?
If your Indesit Dishwasher doesn't start or cannot be controlled, ensure the water supply tap is turned on and the appliance is properly plugged in, trying another electricity socket if necessary. Also, make sure the dishwasher door is closed properly. You can also try switching the appliance off and on again after a minute and resetting the wash cycle.
General| Type | Built-in |
|---|---|
| Energy Efficiency Class | A+ |
| Noise Level | 51 dB |
| Water Consumption per Cycle | 11 L |
| Number of Wash Programs | 4 |
| Appliance placement | Built-in |
| Washing class | A |
| Drying class | A |
| Delay Start | Yes |
| Half Load Option | No |
| Number of Place Settings | 13 |
| Programs | Eco, Intensive, Normal |
