Indesit DIFP 48M User Manual (English)

Questions and Answers:

B
Bridget MorrisAug 16, 2025
What to do if my Indesit DIFP 48M does not take any water and beeps?
- J
  James MartinezAug 16, 2025
  If your Indesit Dishwasher doesn't take in water and emits several short beeps, with the ON/OFF indicator light flashing and the number 6 appearing on the display, it could be due to several reasons. First, check if there is water in the mains supply. If not, turn on the tap, and the appliance should start after a few minutes. Also, the appliance lock may have been activated because no action was taken when the beeps sounded. In this case, switch off the dishwasher using the ON/OFF button, turn on the tap, and switch the appliance back on after 20 seconds by pressing the same button. Reprogram the appliance and restart the wash cycle.
C
Carol FloresAug 19, 2025
Why won't my Indesit DIFP 48M start or respond to controls?
- V
  Vickie PatelAug 19, 2025
  If your Indesit Dishwasher doesn't start or cannot be controlled, it might be due to the appliance not being plugged in properly. Another possibility is that the dishwasher door has not been shut properly. In either case, switch off the appliance by pressing the ON/OFF button, switch it back on after approximately one minute, and then reset the program.
J
juliaclarkAug 22, 2025
What to do if the dishes are not clean in my Indesit Dishwasher?
- M
  Mrs. Annette AyalaAug 22, 2025
  Several factors can cause your dishes to come out unclean from your Indesit Dishwasher. The racks might be overloaded, or the crockery might not have been arranged well. Check that the sprayer arms can move freely. Also, an excessive amount of foam may have been produced because the detergent has not been measured out correctly or it is not suitable for dishwashers. Ensure that the lid on the rinse aid compartment has not been shut correctly. The filter may be dirty or blocked. The refined salt level may be low.
Z
Zachary LoveAug 25, 2025
Why won't water drain from my Indesit DIFP 48M Dishwasher?
- S
  sarah30Aug 26, 2025
  Reasons for no water draining from your Indesit Dishwasher: the dishwasher cycle has not yet finished; the water inlet hose is bent; the drain duct is blocked; the filter is clogged up with food residues.
J
jessicamartinezAug 28, 2025
Why isn't my crockery drying properly in Indesit Dishwasher?
- D
  Daniel MartinAug 28, 2025
  If the crockery isn't drying properly in your Indesit Dishwasher, it could be because a wash cycle without a drying program has been selected. The rinse aid may have been used up, or the dosage is too low. The rinse aid dispenser setting may not be suitable. The crockery may be made from non-stick material or plastic.
J
jennifer66Aug 31, 2025
How to fix Indesit Dishwasher water inlet hose alarm?
- L
  Lisa ArcherAug 31, 2025
  To address a water inlet hose alarm or a blocked water inlet filter on your Indesit Dishwasher (indicated by the ON/OFF indicator light flashing and the number 7 appearing on the display), switch off the appliance by pressing the ON/OFF button. Shut off the water tap to eliminate the risk of flooding and remove the plug from the electrical socket. Make sure the water inlet filter has not become blocked by impurities.
A
Alexis CantrellSep 3, 2025
Why is my Indesit DIFP 48M Dishwasher making so much noise?
- D
  David BrownSep 3, 2025
  Excessive noise from your Indesit Dishwasher can be caused by a couple of things. The dishes might be rattling against each other or against the sprayer arms. Another cause could be an excessive amount of foam produced because the detergent hasn't been measured out correctly or isn't suitable for dishwashers.
R
rileymeredithSep 6, 2025
What to do if my Indesit DIFP 48M Dishwasher door won’t close?
- L
  lisa94Sep 6, 2025
  If the door of your Indesit Dishwasher won’t close, it might be because the lock was released. To solve this, strongly push the door until you hear a “clacking” noise.
S
stephen02Sep 9, 2025
Why are there white film or limescale deposits on dishes from my Indesit Dishwasher?
- R
  robertsonalyssaSep 9, 2025
  If your dishes and glasses are covered in a white film or limescale deposits after being washed in your Indesit Dishwasher, it could be due to several reasons. The level of the refined salt may be low, or the dosage setting might not be suited to the hardness of the water. Another possibility is that the lid on the salt dispenser is not closed properly, or the rinse aid has been used up or the dosage is too low.
K
kristenolsonSep 12, 2025
Why do dishes have a bluish tinge from my Indesit Dishwasher?
- A
  Andre JacksonSep 12, 2025
  If the dishes and glasses from your Indesit Dishwasher are streaked or have a bluish tinge, the rinse aid dosage is too high.

Indesit DIFP 48M Specifications

General

Drying Performance	A
Cleaning Performance	A
Delay Start	Yes
Half Load Option	Yes
AquaStop function	Yes
Product size	Full-size
Washing Programs	Eco, Intensive, Normal
Delay Start (max)	24 hours