3
General Description
This manual describes the method of installation and hardware operation of
the ‘Smart PRO’, where the Smart PRO is a permanently installed electric vehicle
charging solution for resistive domestic and commercial loads of at least 6A
and up to 32A at 230V, 50Hz.
Smart PRO has 3 build variants:
• Smart PRO Type 1 (190105A101) has a SAE J1772 (Type 1) tethered charging
connector to be used with Type 1 socket fitted EVs
• Smart PRO Type 2 (190105A102) has an IEC 62196 (Type 2) tethered
charging connector to be used with Type 2 socket fitted EVs
• Smart PRO Type 2 Socket (190105A103) can be used with multiple types
of charging cables, provided at least one end of the cable is fitted with an
IEC 62196 male connector
Overview and Intended use environment
The Smart PRO can be classified as a ‘smart’ electric vehicle charging solution because
of its communications infrastructure which allows charging to be remotely optimised
by the ‘Kaluza’ smart grid platform; where charging can take place when electricity is
cheapest; or if immediate charging is required, its ‘Boost’ functionality overrides any
smart grid criteria and provides instantaneous charging capability.
Charging using the Smart PRO can take place at up to 7kW, but due to
modulation capability (measured by the external CT clamp) this power
output level can also be reduced.
The Smart PRO is intended for both indoor and outdoor installation, securely
mounted to any retaining wall.
In its operating environment, the temperature must be between -20 and 50°C,
with humidity between 10% to 85% non-condensing. Supply voltage should be
230V AC at 50Hz, rated up to 32Amps, to allow for maximum charging capability.
To Next Page
