Troubleshooting continued
Charging Status LED Off
EV Disconnected
Connect the EV to the Smart PRO to enable scheduled or
Boost charging. Where an untethered cable is being used, ensure
the device end is plugged in first, before plugging the opposite
end into the EV.
Charging Status LED White, Cycling Downwards
Charging Mode
The charger is currently charging the vehicle.
Charging Status LED White, Flashing**
Delay Mode
The charger knows a vehicle is connected but is currently idle.
Either the vehicle is fully charged or awaiting a scheduled
charge. If neither of the above applies, contact
Customer Support.
Charging Status LED White, Solid
Idle Mode
The charger is currently idle and not charging.
Servicing, Maintenance & Support
The Smart PRO MUST NOT be repaired by the
customer. Repair of the charger is to be carried
out ONLY by the manufacturer or their approved
installation partners.
In the case that any Smart PRO system safety
component (defined as any breaker, fuse, limit
cut out, enclosure, grounding equipment) fails
completely or partially; maintenance or
replacement of the charger may be required.
53
To Next Page
