Need help?Do you have a question about the Indus Technologies IDEX 400 and is the answer not in the manual?
General| Switching Capacity | 128 Gbps |
|---|---|
| MAC Address Table | 16K |
| Jumbo Frame Support | 9K bytes |
| Power Input | 100-240V AC, 50/60Hz |
| Operating Temperature | 0°C to 45°C |
| Ports | 24 x 10/100/1000Base-T ports, 4 x 10G SFP+ slots |
Explains the two modes of operation: Local and Master, determining how the active drive is selected.
Details the function of the 'Active Drive' and 'Master' LED indicators on the IDEX 400 front panel.
Lists the computer requirements for the IDEX 400, including drive bay and SATA port needs.
Guides decisions on physically connecting drives as 'Drive 1, 2, 3, or 4' within the computer.
Provides examples and guidance on assigning specific functions or operating systems to each connected drive.
Advises on precautions to prevent damage from static electricity during handling and installation.
Explains how to configure the IDEX 400 for Master or Local mode using jumpers and default drive settings.
Instructs to disconnect the computer's power cable before proceeding with installation.
Details the process of disconnecting the power and data cables from the current hard drive.
Recommends marking power and data cable connectors for easy identification and setup.
Guides on securely mounting additional hard drives in the computer tower to prevent issues.
Provides instructions for installing an optional jumper cable for Master Selector functionality.
Explains how to connect SATA data cables from the motherboard to each hard drive.
Details connecting hard drive power cables to each installed hard drive.
Guides connecting internal PC power, drive power out cables, and optional master selector cables to the IDEX 400.
Instructions for mounting the IDEX 400 unit into the computer's drive bay using screws.
Provides step-by-step procedures to test the IDEX 400 functionality in Local and Master modes.
To Next Page