page 7
IDEX 400 SATA - Installation & Operation
2. Disconnect All Power To Computer
Disconnect the power cable from your computer.
3. Disconnect Existing Hard Drive
Disconnect the power and data cable from the existing hard drive.
4. Mark Cables
Note: All four positions on the IDEX 400 are identical and any position can be used. To simplify these instructions,
position 1 & 2 are assumed.
Designate one set of power and data cables as drive position one by marking the connectors on both ends of both cables
with a “1”. Mark the second set with a “2”. This is done for simplicity in setup and to aid in any trouble-shooting later.
5. Install Second Hard Drive
Mount the your second ( third and fourth ) drive into the tower securely. A poorly mounted drive can cause excessive
noise, may result in loose cables, and might reduce the life span of a hard drive due to vibration.
6. – OPTIONAL – Install Master Selector Jumper Cable ( Not Included In Kit )
See web site for additional installation instructions regarding installation of Master Selector.
Hard Drive Power Cable
SATA Data Cable ( Not In Kit )
To Next Page
Loading...
Need help?
General