4 – Inepro Metering – PRO Series
• Maintenance and repair of the meter should only be carried out by qualified personnel.
• Never break any seals (if present on this meter) to open the front cover as this might influence
the functionality or accuracy of the meter, and will void all warranty.
• Do not drop, or allow physical impact to the meter as there are high precision components
inside that may break and affect the meter measurement negatively.
• All clamps should be properly tightened.
• Make sure the wires fit properly in the connection clamps.
• If the wires are too thin it will cause a bad contact which can spark causing damage to the
meter and its surroundings.
Exclusion of liability
We have checked the contents of this manual and every effort has been made to ensure that the
descriptions are as accurate as possible. However, deviations from the description cannot be completely
ruled out, so that no liability can be accepted for any errors or omissions in the information given. The
data in this manual are checked regularly and the necessary corrections will be included in subsequent
editions. If you have any suggestions, please do not hesitate to contact us.
Subject to technical modifications without notice.
Copyright
Copyright Inepro Metering August 2011.
It is prohibited to pass on or copy this document or to use or disclose its contents without express
permission of Inepro Metering BV. Any duplication is a violation of the law and subject to criminal and
civil penalties. All rights reserved, particularly for pending or approved patent awards or registered
trademarks.
To Next Page
Loading...
