infaco F3020 - DSES System First Use and Calibration; Calibration and Glove Recommendations; Authorized vs. Prohibited Gloves

21
First use
The first time you use the equipment, we strongly recommend seeking the advice of your
dealer, who is qualified to provide instructions on the proper use of the system.
To guarantee an optimal level of safety and also to reduce unwanted activations,
it is strongly recommended to calibrate the DSES system (see page 24) and to
wear an INFACO brand conductor glove on the hand opposite the one holding the
pruning shears.
It is essential that users be bare-handed or wearing INFACO brand conductor
gloves (ref. GWDSES and/or 355G29). This system is totally incompatible with all
other types of gloves and under-gloves.
Authorized gloves
Examples of prohibited gloves
Conductor gloves on
the hand opposite the
pruning shears:
• ref.: 355G29 (right-
handed)
• ref.: 355G29G (left-
handed)
Conductor glove on the
hand carrying pruning
shears:
• ref.: GWDSESD (right-
handed)
• ref.: GWDSESG (left-
handed)
Leather Plastic Fabric
IMPORTANT:
The use of INFACO conductor gloves is strongly recommended to:
• Increase the safety system conductivity.
• To make the reactivity consistent on the entire hand surface.
• Reduce unwanted triggering on wet wood and/or wood that is too close to
the ground.