24
Untimely triggering:
In certain working conditions, the safety system can be triggered during a cut:
• on very wet wood (due to very bad weather for example),
• on cuts close to the ground,
• near metal stakes and wires.
To make those types of cut, use the deactivation functions mentioned above.
In those cases, you are no longer protected.
Wearing an INFACO conductor glove combined with safety system calibration reduces the
rate of unwanted triggering (see system calibration procedure on page 24).
Checking DSES system correct operation and calibration
The "DSES check" function is carried out when the pruning shears are in standby mode and
checks correct system operation (with bare hands or conductor gloves)
This check should be carried out before starting work and several times a day:
• Check the cleanliness of your cutting head. Dirt can alter both the conductivity
and the correct operation of the safety system.
• If conductor gloves are worn, the first daily DSES check should be carried out
on dry gloves and on the entire glove surface.
1. Put the pruning shears on standby
2x
2. Press the trigger and keep it pressed. After one second, DSES check mode is activated.
The DSES LED flashes, the power LED turns steady red.
To Next Page
Loading...