12
Vortex Operating Manual
6.0 Service
6.1 General
DO NOT CHANGE any of these components as the safety of the
machine could be compromised. All service work must be performed at
an INFICON approved facility in order to maintain the safety rating and
the Warranty, if applicable.
Technical assistance and service information can be obtained through your
local sales organization.
NOTE: Do not return a defective unit directly to the factory. Contact your
Wholesaler or the factory for assistance.
The following Parts and Accessories for your Vortex are available through the
same dealer from whom you purchased the unit:
Item Part #
Thomas 500 Compressor, 230 V(dc) 708-408-P1
Bridge Rectifier, 25 A, 600 V 052-0206
Capacitor Assembly, 470 µf, 400 V 600-1205-P2
Circuit breaker, 125/250 V, 4 A 062-0082
Cord set, IEC plug, 230 V 068-0399
On/Off Switch 065-0261
Manifold Assembly with extensions and fittings 708-403-P1
Gauge, High Pressure for Vortex Model 708-202-P2 708-402-P1
Gauge, Low Pressure for Vortex Model 708-202-P2 708-401-P1
Gauge, High Pressure for Vortex Model 708-202-P10 M1002V18B -
8252PA
Gauge, Low Pressure for Vortex Model 708-202-P10 M1002V18B -
8253PA
Pressure Switch, high pressure cutout 032-0055
Condenser Assembly with tubes 708-204-G1
Case Housing - right side 708-306-P1
Case Housing - left side 708-307-P1
Strap, shoulder 708-404-P1
Cap and strap, plastic with lead 070-1107
Handle, SS tube 708-311-P1
To Next Page
Loading...