What to do if InfiniSolar Hybrid 3kW Inverter works in battery mode when mains exist?
If your InfiniSolar Inverter continues to operate in battery mode even when mains power is available, it could be due to a tripped input protector. Verify that the AC breaker hasn't tripped and that the AC wiring is securely connected.
Why InfiniSolar Hybrid 3kW has no response after power on?
If your InfiniSolar Inverter isn't responding after you power it on, it could be due to several reasons: * The battery voltage might be critically low (less than 1.4V/Cell). Check the battery and wiring connections to ensure they are secure. You may need to recharge or replace the battery. * The battery polarity might be reversed. Double-check the connections to ensure correct polarity, and then attempt to recharge or replace the battery.
How to fix InfiniSolar Inverter that shuts down automatically during startup?
If your InfiniSolar Inverter shuts down automatically during the startup, it's likely because the battery voltage is too low (less than 1.91V/Cell). To resolve this, try recharging the battery. If the issue persists, consider replacing the battery.
Important safety and operating instructions for reading and future reference.
Details on recommended cable size, terminal size, and connection steps.
Details on connecting AC input and output wires with recommended cable size.
Details on connecting PV modules, including recommended cable size and module selection.
Describes how to turn the unit on and off using the switch.
Lists common problems, their causes, and recommended solutions.
General| Output Voltage | 230VAC |
|---|---|
| Max. Charging Current | 60A |
| Output Frequency | 50/60Hz |
| Rated Power | 3000W |
| Battery Type | Lead-acid or Lithium-ion |
| Communication | RS232/USB |
| Protection | Overload, short circuit, over temperature |
| Operating Temperature | 50°C |
To Next Page
