9.3 After installing the hob, make sure that
• The power supply cable is not accessible through cupboard doors or
drawers.
• There is adequate flow of fresh air from outside the cabinetry to the base of
the hob.
• If the hob is installed above a drawer or cupboard space, a thermal
protection barrier is installed below the base of the hob.
• The isolating switch is easily accessible by the customer.
9.4 Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do
not apply force onto the controls protruding from the hob.
9.5 Adjusting the bracket position
Fix the hob on the work surface by screw 2 brackets on the bottom of hob(see
picture) after installation.
Adjust the bracket position to suit for different table top thickness.
To Next Page
Loading...
