CARE OF YOUR SPEAKER SYSTEM
The black-ash or cherry wood finish does not require any routine
maintenance. When needed, use a soft cloth, dampened with water only,
to remove any fingerprints or to wipe off dust. Clean the grille by gentle
vacuuming or with a damp cloth.
NOTE: Do not use any cleaning products or polishes on the cabinet or griUe.
For maximum acoustic transparency_ the grille uses a lightweight
structure that needs to be handled with care for removal. To remove the
grille, gently pull on the corners to unfasten the frame from the cabinet.
To replace it, make sure to align the frame pins first and then gently
snap the frame into place. Never force the grille frame onto the cabinet.
TROUBLESHOOTING*
SYMPTOM CAUSE SOLUTION
ooe Qeoe e•e • • •oe • • •o ••e oe •eo oo•• o••ee• • • •••o•e e•oeo •e o• eo ee eeee •e•• •ee• ee• oeee •ee e•o eo • • • •
Bass is too loud Bass reinforcement, Move speakers away
in room from walls
Bass level is too high Rotate BASS control
towards "1"(see page 7)
e• •• • • e• • oeo•eo• • • • • • •oe• e•e •eoe •• oe • e• • • • ee •• ••ee•eeeee • e•••• • • • •e• • • •• o•eoe •e• • • eee••e•
Bass sounds
distorted
Subwoofer amplifier
has reached maximum
output
Bass level on preamp/
receiver is set too high
Turn down volume
control on receiver
or preamplifier
Set bass and treble flat;
use controls sparingly
• e• e•e•• ee • o•oeo eo •e ee • • • e•• •oo$ •o•ee e••• •oQ
ooo ee • • ee oeee ee oeee• eeeo•e • • • e.o eoe ee eoeo oeoe
Distortion with Defective receiver or Repair defective
volume control preamplifier, shorted receiver or
near minimum speaker wires preamplifier,
Distortion on music
or effects peaks
(e.g., pops or noise)
o• ee •oe el oo• • eeQe• ee • oee• • e• • o••••e coo• eoe• • • eee
e•e •oe ,• •e••o • • •o• • oo e•• • • eooee e• oeo eee • o
Dynamic soundtrack Turn down master
causes subwoofer volume control to
to "bottom" out lower overall range
Tone controls
are set too high
Set bass and treble fiat;
use controls sparingly
Buzz, hum, or Connecting wires Connect wires only
crackle when with power on causes when audio system
connecting wires transient signal spikes power is off
oeeoee•ee •e • Qe •e •lee eeoeeo • eoeeeeeooeo•oo ••• o• •o •• oeeeoe• eee e•ool • oloe e • ee ee oee •e• eeoo eoe
No sound from
speaker system;
power LED not on
Power cordnot Connect acpower cord;
connected;no ac power checkac outlet
Blown fuse Check or replace fuse
(see page 7)
*Ifyou need further assistance, contactyourlocalInfinity retail dealer.
8 * Compositions Overture OVTR 3 - Owner's Manual