Infinity Kappa Series 3-Way Component System 1.1cs User Manual

Thank you for purchasing an Infinity Kappa Series 3-Way
Component System. We’ve organized this manual to make your installation
as simple and trouble-free as possible. Please read it thoroughly before
proceeding. Remember to keep your sales receipt with this manual in a
safe place so both are available for future reference.
®
K APPA S ERIES
653.1cs, 1.1cs
INSTRUCTIONS
Kappa 653.1cs OM 7/14/98 10:10 AM Page 1

Infinity Kappa Series 3-Way Component System 1.1cs Specifications

General

Type	3-Way Component System
Tweeter Composition	Textile
Woofer Composition	Polypropylene
Woofer Surround	Rubber
Impedance	4 Ohms
Midrange Size	4 inches
Tweeter Size	1 inch
Tweeter Design	Dome
Woofer Size	6-1/2"

Summary

Welcome and System Introduction

Thank You Message

Expresses gratitude for purchasing the Infinity Kappa Series system and provides initial guidance.

Important Installation Guidelines and Tips

Important Installation Notes

Highlights the need for experienced installers and professional options if needed for vehicle audio systems.

Speaker Placement Advice

Offers guidance on optimal speaker positioning for improved stereo imaging and treble response.

Installation Warnings and Safety

Details crucial safety precautions, tool usage, and electrical disconnects before starting installation.

Wiring Codes and Diagrams

Single Stereo Amplifier Wiring

Illustrates wire connections for a Kappa system using a single stereo amplifier setup.

Advanced Wiring Configurations and Component Installation

Bi-Amp Wiring Configuration

Shows how to connect the Kappa system to two amplifiers using a bi-amplification setup.

Tri-Amp Wiring Configuration

Details connections for a Kappa system using three amplifiers in a tri-amplification setup.

Woofer Installation Guide

Provides instructions and figures for installing the Kappa woofers, including spacer use.

Midrange Installation Guide

Illustrates the process for installing the midrange drivers into a door panel.

Tweeter Installation Guide

Explains how to mount and secure the Kappa tweeters using provided plates and clips.

System Tuning, Operation, and Specifications

Adjusting the Sound Output

Describes how to adjust speaker output levels via the crossover for desired sound tuning.

Power Handling and Amplifier Use

Advises on proper amplifier power levels to prevent speaker damage from signal clipping.

General Care and Maintenance

Offers simple instructions for cleaning loudspeaker grilles without damaging the material.

Technical Specifications

Lists detailed technical data for the 653.1cs and 1.1cs models, including dimensions and frequency response.

Declaration of Conformity

States compliance with technical standards as per the CE marking requirements.