EYE MODE
The Eye Mode can be set to four different modes:
The anti-chop system is disabled. When this occurs, the maximum rate of fire is limited to 13 balls per
second to help prevent chopping of balls in the breech.
In this mode, the marker will not fire unless the eye system detects something in the breech. This
mode uses a rate of fire cap to determine the maximum cycling speed. The eye system will never be
automatically bypassed in this mode, as the bolt is not monitored.
In this mode, the marker will not fire unless the eye system detects something in the breech. This mode
works by monitoring the bolt position, thus the maximum rate of fire is unlimited.
Eye Mode 4
(Simulate Mode)
In this mode, a ball is simulated to be in the breech. This allows the user to fire the
marker with just air, at full speed the marker is capable of firing. This mode can be
used for practicing trigger pull techniques, without wasting paint. You should not use
paint with this eye mode.
BIP Delay Mode
(Ball In Place Delay)
The BIP Delay is a programmable time delay between when the eye sensor first sees
the ball until the bolt starts its forward travel. The BIP Delay is a feature that allows
you to adjust for differences in the eye sensor, and the loader being used. When
using a slower gravity feed loader, it may be necessary to have a longer BIP Delay to
prevent balls from being chopped.
Possible values are from 1ms to 50ms. The factory default is 3ms. Changes are
made in 1ms units.
Technical Support
Our Technical Support Department is open
Tuesday Through Saturday from 11am to 6pm , PST
We can be reached at 310-914-3481
You can also E-mail your technical questions to
info@innitypaintballproducts.com
Patent Pending
Innity Paintball Products, LLC
11919 W. Pico Blvd, Los Angeles, CA 90064
To Next Page
Loading...