_______________________________________________________Operation and Care
Manual conversion:
Auto-Fill™ option can be simply reset to normal manual mode as a contingent system when automatic
operation becomes unavailable. Please call our Customer care for step by step instructions.
Auto-Fill™ / Jet Switch:
(Dual-functional momentary switch located on the right side of the front panel)
1. T
o turn water on: Turn knob clockwise for 1 second and release. Water will fill up to reach th
e
sensor level and activate the whirlpool jets
2. T
o turn water off: Turn knob clockwise for 1 second and release to turn off water. The switch
can be activated to turn on or turn off water any time during the Auto-Fill™ cycle, EXCEPT when
water is at sensor level.
3. T
o turn On / Off the whirlpool jet: Turn knob clockwise for 1 second and release. This Jet
cannot be turned on if water level is not at sensor level. Turn this jet knob when water level is
low; the system will resume with fill up water prior activating whirlpool jet.
Drain Switch:
(Dual Action Electro-mechanical Switch located on the left side of the front panel)
When activating the switch, it will raise the drain-stopper and power up the drain pump (if exist) at the
same time.
1. T
o drain water: Turn the drain knob clockwise. Drain pump is activated.
2. To turn off the drain pump: Turn the drain knob counterclockwise.
CAUTION: Reset the Drain knob to vertical position to close the drain stopper prior fill up water
To Next Page
Loading...