CHARGING
1. Fully charge battery for up to 3 hours before first use.
2. To charge, connect DC end of the supplied 24V adapter to the
battery’s charging port and plug AC side cable into wall outlet.
3. In Standby mode, the LED lights on the device control panel flash
regularly, indicating the battery level and that it is charging. The ring
on the bottom of the battery pack also flashes and changes color to
indicate battery charge. If the battery switch on the bottom of the
battery pack is Off, only the battery pack ring will flash from yellow to
green, when battery is fully charged, battery ring will stop flashing
and stays on green.
4. Battery may be recharged at any time and at any battery level. Do
not use this device while charging.
5. One flashing light on the control panel indicates low power and the
battery needs to be recharged.
OPERATION
1. Make sure battery power button on the bottom of the battery is
turned on and the battery ring is lit indicating that the device is in
standby mode. If the ring is not lit, press the battery power button
again to turn on the unit.
2. Press the power button on front of the handle to turn device on.
3. Device will start at speed level 1. To cycle through the 5 different speed
levels press the power button on the front of the handle. When the
device is at speed level 5, press the power button once more to enter
standby mode (speed level 0). To restart, wait 3 seconds and then
press the power button on front of the handle to enter speed level 1
again.
4. At any time after turning on the device, press and hold the power
button on front of the handle to enter standby mode.
5. To completely turn off, press battery power button on the bottom of
the battery. Battery ring will turn off to indicate unit is off.
6. If the device is left idle in standby mode for 60 minutes it will
automatically turn off.
6
5
To Next Page
Loading...
