8
To power up the chair, flip the main power switch located on the back of the base of the
chair to ON.
Main Power Switch
Getting Comfortable
Chair Setup
Select any auto program. The chair will automatically begin scanning your body, mapping
your back, shoulders, and neck. During this process its is importing to remain seated back
into the chair without lifting your head.
The scan can be viewed on the remote control screen. If fine tuning is needed just after
your body scan, wait for a series of beeps to start, then immediately use the Roller Position
buttons on the bottom of the remote control to move the massage rollers up or down for
the perfect shoulder kneading position.
Truefit
TM
Body Scanning
Take a seat in the chair and take note of where the neck
pillow rests on your neck. Adjust the pillow so that it rests
comfortably in the arch of your neck. Do this by removing it
from the velcro, aligning it, and then reattaching to the velcro
once it is in the desired position.
Adjust Pillow
Main
Power Switch
Power
Cord Input
Fuse Location
- When not in use for a long period of time, we recommend that the chair be covered, the power cord be coiled
and that the unit be placed in an environment free of dust and moisture.
- To avoid possible damage to product or injury to unsupervised children, always turn off power switch and
unplug massage chair from electrical outlet immediately after use.
CAUTION
Neck Pillow
To Next Page
Loading...
