Infoblox Infoblox-2000-A User Manual

Changing Disk Drives
For the Infoblox-2000-A Appliance 19
• All disks in the RAID array should have the same disk type for the array to function properly.
• In the unlikely event that two disk drives fail simultaneously and the appliance is still operational, remove and
replace the failed disk drives one at a time.
• Rebuild time can vary. The rebuild process takes approximately two hours on an idle appliance. On very busy
appliances (over 90% utilization), the disk rebuild process can take as long as 40 hours. On a grid master
serving a very large grid, expect the rebuild process to take at least 24 hours.
• Replace a failed or mismatched disk only with a replacement disk shipped from Infoblox. When you request a
replacement disk, report the disk type displayed in the
Detailed Status panel of the Infoblox GUI or the
Infoblox part number on the disk.

Infoblox Infoblox-2000-A Specifications

General

Brand	Infoblox
Model	Infoblox-2000-A
Category	Network Router
Language	English