Infoblox Trinzic Reporting 1400 User Manual

Changing AC Power Supplies
For the Trinzic Reporting 1400 Appliance 25
Note: IP settings and basic network configurations, such as the gateway address, netmask, Grid secret and
Grid name, are saved and restored when you replace a failed disk drive.
Changing AC Power Supplies
Note: Before changing the power supply, make sure it is securely cabled. An apparently failed power supply may
simply be improperly connected to its power source.
The Trinzic Reporting 1400 ships with one AC power supply. When the power supply fails for any reason, the
Infoblox GUI displays a power supply alarm. The Grid Status widget on the Dashboard of the GUI also displays an
error. The appliance sends an email notification and reports an SNMP trap.
Figure 14 illustrates the process of
replacing an AC power supply.
Each power supply weighs about one pound (0.454 kg). The faceplate of the power supply contains a power LED and
a power switch. Each AC power supply provides a dedicated power outlet.
Note: If your appliance comes with one power supply and an empty module, ensure that the power supply is in the
PSU #1 slot and the empty module in the #2 slot. You cannot switch them.
Figure 14 Removing a Trinzic Reporting 1400 AC Power Supply
Handle
Catch-release lever
(black)

Infoblox Trinzic Reporting 1400 Specifications

General

Brand	Infoblox
Model	Trinzic Reporting 1400
Category	Network Hardware
Language	English