30
Timer
Auto Off Time: aut
omatically turns the projector off after no signals are
detected for a preset number of minutes. If an active signal is received before
the projector powers down, the image will be displayed.
High Altitude Setting
High Altitude: W
e recommend you turn on the High Altitude Mode when
your environment is between 5000' (1500m) and 10,000' (3000m) above sea
level.
Status/Service:
Source Info: a read-only display of current source settings.
Projector Info: a read-only
display of current projector settings and lamp
hours.
Reset Lamp Hours...: resets
the lamp hours used counter in the Projector Info
menu to zero. Do this only after changing the lamp.
Factory Reset...:
restores all settings to their default.
Service Code...: only used by authorized service
personnel.
To Next Page
Loading...
Need help?
General
