29
Timer
Auto Off Time: automatically turns the projector off after no signals are detected for
a preset number of minutes. If an active signal is received before the projector powers
down, the image will be displayed.
High Altitude Setting
High Altitude: We recommend you turn on the High Altitude Mode when your envi-
ronment is between 5000' (1500m) and 10,000' (3000m) above sea level.
Network
Wireless LAN
SSID: Display the projector’s SSID information.
IP Address: a read-only display of IP Address.
Subnet Mask: a read-only display of Subnet Mask.
Restart Network...: Restart network settings.
Status/Service:
Source Info: a read-only display of current source settings.
Projector Info: a read-only display of current projector settings and lamp hours.
Reset Lamp Hours...: resets the lamp hours used counter in the Projector Info menu
to zero. Do this only after changing the lamp.
Factory Reset...: restores all settings to their factory default settings..
Service Code...: only used by authorized service personnel.
Controlling the projector through a WLAN
environment
You can manage the projector from a computer using a web browser when the
computer and the projector are properly connected to the same local area
network.
To connect to the projector wirelessly, you need to plug an optional InFocus
wireless dongle (p/n SP-WIFIUSB-2) to the USB Type A connector on the
projector.
How to setup AP mode:
1 Select Type-A from source list.
2 Go to Settings > WiFi, select AP Mode and set it to ON. See page 42. AP
mode is set to ON by default.
3 Select WLAN from source list. AP Info page displays.
How to setup client mode:
1 Select Type-A from source list.
2 Go to Settings > WiFi, select Client Mode and set it to ON. See page 42.
3 Choose the Wi-Fi network which the projector connect to from the Wi-Fi
InFocus wireless dongle
(p/n SP-WIFIUSB-2)
AP Info
AP IN124a-380343
IP 192.168.111.1
PSK
PassCode
3522
To Next Page
Loading...
Need help?
General
Weight and Dimensions
