To Next Page
R
Rachel BrooksAug 18, 2025
How to fix a reversed image on InFocus IN114?
- MMichael BakerAug 18, 2025
If the image is reversed left to right on your InFocus Projector, turn off Rear Project in Advanced Menu > Setup > Image Setup... menu.
How to fix a reversed image on InFocus IN114?
If the image is reversed left to right on your InFocus Projector, turn off Rear Project in Advanced Menu > Setup > Image Setup... menu.
Why won't the lamp turn on and the InFocus Projector is overheating?
If the InFocus Projector is overheating and the lamp won’t turn on, ensure that the vents are not blocked. Turn off the projector and allow it to cool for one minute.
How to fix a fuzzy or cropped image on my InFocus IN114 Projector?
To correct an image that is fuzzy or cropped on your InFocus Projector, change the computer's "Resolution" setting to match the projector's resolution. This can typically be found in the Control Panel under Display settings.
What to do if only laptop background appears on InFocus IN114 Projector?
If you are only seeing your laptop’s background and not the Desktop icons on the InFocus Projector, change the Multiple Display setting to "Duplicate these displays". This setting can usually be found in the Control Panel under Display > Screen Resolution.
How to flip the image on InFocus IN114?
To resolve an upside-down image on your InFocus Projector, turn off Ceiling Mount in the Basic menu.
How to adjust colors on InFocus Projector?
If the projected colors don’t match the source on your InFocus Projector, adjust the items in the Advanced Menu > Image > Color... menu.
How to correct a not square image on InFocus IN114 Projector?
To correct the image if it is not square on your InFocus Projector, adjust the Keystone setting on the keypad.
What to do if InFocus Projector says 'Signal out of range'?
If the InFocus Projector shows "Signal out of range", press the Auto Image button on the remote. You may also need to adjust the computer refresh rate (Windows 7: Control Panel > Display > Screen Resolution > Advanced Settings > Adapter tab) and/or set a different resolution on your computer.
How to make the image sharper on InFocus IN114 Projector?
To fix an image that is not sharp on your InFocus Projector, adjust the Sharpness in the Basic Menu.
How to center the image on my InFocus Projector screen?
To correct an image that is not centered on the screen with your InFocus Projector, move the projector and adjust the height. You can also adjust horizontal or vertical position in Advanced Menu > Previous Image > PC... menu.
General| Matrix size | 0.55 \ |
|---|---|
| Number of colors | 1.073 billion colors |
| Native aspect ratio | 4:3 |
| Projection distance | 1.5 - 11.9 m |
| Projection technology | DLP |
| Supported aspect ratios | 4:3, 5:4, 16:9, 16:10 |
| Contrast ratio (typical) | 4000:1 |
| Screen size compatibility | 40 - 303 \ |
| Projector native resolution | XGA (1024x768) |
| Keystone correction, vertical | ± 40 ° |
| Vertical synchronization (max) | 120 kHz |
| Vertical synchronization (min) | 50 kHz |
| Horizontal synchronization (max) | 100 kHz |
| Horizontal synchronization (min) | 31 kHz |
| Projector brightness (economic mode) | 2200 ANSI lumens |
| Focus | Manual |
| Offset | 15 % |
| Throw ratio | 1.97 - 2.17:1 |
| Zoom capability | Yes |
| Focal length range | - mm |
| Lamp type | UHP |
| Lamp power | 180 W |
| Light source type | Lamp |
| Lamp power (economic mode) | 150 W |
| Service life of light source | 5000 h |
| Service life of light source (economic mode) | 6000 h |
| DVI port | No |
| USB connector type | Mini-USB B |
| HDMI ports quantity | 0 |
| Serial interface type | RS-232 |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| S-Video inputs quantity | 1 |
| VGA (D-Sub) ports quantity | 3 |
| Component video (YPbPr/YCbCr) in | - |
| Supported video modes | 1080i, 1080p, 480i, 480p, 576i, 576p, 720p |
| Analog signal format system | NTSC, PAL, SECAM |
| Supported graphics resolutions | 1920 x 1200 (WUXGA) |
| RMS rated power | 2 W |
| Placement | Desktop, Ceiling |
| Product type | Standard throw projector |
| Product color | Black |
| Cable lock slot type | Kensington |
| Power source | AC |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (max) | 260 W |
| Power consumption (standby) | - W |
| Power consumption (typical) | 235 W |
| Noise level | 30 dB |
| Preset modes | Beige wall, Blackboard, Bright, Cinema, Custom, Presentation, Whiteboard |
| Certification | UL, c-UL, FCC, CE |
| Password protection type | User |
| Noise level (economic mode) | 28 dB |
| On Screen Display (OSD) languages | CHI (SIMPL), CHI (TR), DAN, DEU, DUT, ENG, ESP, FIN, FRE, ITA, KOR, NOR, POL, POR, RUS, SWE, TUR |
| Operating altitude | 0 - 3048 m |
| Operating temperature (T-T) | 5 - 35 °C |
| Cables included | AC, VGA |
Weight and Dimensions| Depth | 235 mm |
|---|---|
| Width | 284 mm |
| Height | 70 mm |
| Weight | 2170 g |
| Package width | 330 mm |
| Package height | 150 mm |
| Package weight | 3670 g |
Manufacturer's statement of product compliance with directives and norms, including FCC and agency approvals.
Solutions for common projector problems including display, image quality, and operational issues.
Common adjustments for projector settings like aspect ratio, brightness, and volume.
Access to complex settings for deeper customization, detailed in subsequent sections.
Proper method for cleaning the projector lens using safe materials.
Guidance on attaching and using a cable lock system for security.
