29
Service menu
Model: Displays the model number of the projector (read-only).
Serial Number: Displays the serial number of the projector (read-only).
Software Version: Di
splays the current firmware version the projector is using
(read-only).
Active/PiP Source: Di
splays the source type which is being used in the Picture-
in-Picture window (read-only).
Pixel Clock: D
isplays the pixel clock settings of the current source (read-only).
Signal Format: Displa
ys the signal format settings of the current source (read-
only).
H/V Refresh Rate: D
isplays the horizontal and vertical refresh rate settings of the
current source (read-only).
Lamp 1 Time: Disp
lays the number of hours Lamp 1 has been used (read-only).
Lamp 2 Time: Displays the number of hours Lamp 2 has been used (read-only).
Power On Time: Disp
lays the number of hours the projector has been used
(read-only).
Blue Only: Dis
plays a blue screen used for color calibration.
Factory Reset:
Restores all settings to their defaults. Note: You must confirm this
before the reset will occur by click “OK” to the Reset Everything? dialog box.
INPUT PICTURE LAMPS ALIGNMENT CONTROL SERVICE
Model : IN5552L
Serial Number : C277XXXX00807
Software Version : ME01-GE02-Ub02-5050-39-DPNE02-P03-E07
Active/PiP Source : VGA / O
Pixel Clock : 83.51 MHZ
Signal Format : 1280x800@60Hz
H/V Refresh Rate : H: 49.726 KHZ V: 60 HZ
Lamp 1 Time : 5 HRS
Lamp 2 Time : 3 HRS
Power On Time : 5 HRS
Blue Only < O >
Factory Reset Enter
To Next Page
Loading...
Need help?
General
