Using LP Utilities
36 LitePro 580 User’s Guide
Using the control icons
The LP-Link function controls are the same as those on the projector
and the remote. Select a button to change its setting. Select and hold
down the mouse button to increase or decrease values. A list of the
controls follows:
LP-Link control icons
Icon Command Function
Standby Turns projector lamp on and off.
(If the LitePro is in standby mode,
this is the only icon that is
displayed.)
Sync (-) Adjusts a flickering or blurred
image. Synchronizes the projector
to the computer or video input
signals.
Sync (+) Adjusts a flickering or blurred
image. Synchronizes the projector
to the computer or video input
signals.
Bright (-) Decreases the brightness of the
image.
Bright (+) Increases the brightness of the
image.
Volume - Decreases the volume.
Volume (+) Increases the volume.
Custom Carries out a function you have
assigned with the Custom Key
menu.
Source Selects either a computer or a
video device as the source of the
signal to be projected.
Freeze Freezes the image. To cancel, click
the icon again.
Mute Shuts off the audio. To cancel,
click the icon again.
Downloaded From projector-manual.com Boxlight Manuals
To Next Page
Loading...
Need help?
General