Infomir MAG256 User Manual

Using Remote Control to control the Device
This section explains how to unpack Remote Control
(RC) and prepare it for work. Your service provider
can supply the product with an alternative RC. In
that case please refer to the manual supplied by
your service provider. Remote Control requires
two batteries type AAA, R03, LR03, UM-4, 286.
Important information about using batteries.
Do not mix dierent types of battery or old and
new batteries.Do not use rechargeable batteries
with the remote control. Remove the batteries from
the remote control if you are not going to use it for
several weeks, to avoid the risk of leakage. Please
respect your environment and any local regulations and
dispose of old batteries in a responsible manner.
Caution! Do not attempt to recharge the
batteries.Immediately remove any leaking
batteries. Take care when handling leaking
batteries as they may cause burns to the skin
or eyes, or other physical injuries.
Introduction to the Programmable
Remote Control Unit (optional)
If MAG256/257, MAG256w2/257w2 package includes
a remote control with a block of ve programmable
buttons (marked with blue print colour), then you may
want to choose these buttons for controlling other
devices (TV set, amplier).
To program the buttons do the following:
• Press the «On/O» and «A/V» buttons at the same
time and hold it for 2 seconds. When the green
light of the «On/O» button will stop blinking and
willlight steadily, it means the RC is ready to learn.
• Press the button you want to «teach» — the green
light will start blinking.
• Place the infrared lamps of two RCs opposite each
other and press the button on the RC of the other
device, the function of which you wish to copy on
device RC. Hold for 2 seconds.
• After the green light two quick blinks you may
continue programming other buttons.
• Repeat the procedure described above for all
buttons you want to program for controlling
external devices.
• Press the the «On/O» and «A/V» buttons to save the
programmed data; the green light should fade o.
Reset
Press SETUP and OK buttons at same time and hold
for 2 seconds red LED will ash 5 times. Reset is done.

Infomir MAG256 Specifications

General

Processor frequency	1.5 GHz
Processor architecture	Cortex-A9
Internal memory	1024 MB
Storage media type	Flash
Card reader integrated	-
Internal storage capacity	0.5 GB
Audio formats supported	AAC, M4A, MP3, MPA, OGG, WAV
Image formats supported	BMP, JPG, PNG, RAW
Video formats supported	ASF, AVI, H.264, H.265, M2TS, MKV, MOV, MP4, MPEG1, MPEG2, Quicktime, VOB, WMV
Operating system version	3.3
Operating system installed	Linux
Subtitle formats supported	MKV, SRT
Wi-Fi	Yes
USB version	3.2 Gen 1 (3.1 Gen 1)
HDMI version	1.4a
Frequency band	2.4/5 GHz
Wi-Fi standards	Wi-Fi 5 (802.11ac)
USB ports quantity	1
Ethernet LAN data rates	100 Mbit/s
Product color	Black
Supported video modes	576p, 720p, 1080i, 1080p
Supported aspect ratios	16:9
Maximum video resolution	1920 x 1080 pixels

Weight and Dimensions

Depth	87 mm
Width	132 mm
Height	26 mm
Weight	190 g