What to do if my Infomir Set-top box is not displaying anything on the TV?
Ensure the TV is properly connected to the device, referring to the connection guide if needed, and that the TV is switched on.
Why is my Infomir Set-top box not working even when connected to power?
Ensure you are using a working electrical outlet that supplies voltage within the range of ~100-240V / 50-60Hz.
How to check the volume on Infomir Set-top box?
Verify the volume level on both your TV and the MAG-200 set-top box to ensure it is audible.
What to do if my Infomir Set-top box is not loading the portal from the local network?
First, check your local network connection. Alternatively, try loading from the device's internal flash memory.
What to do if the Infomir Set-top box is not turning on?
Turn the power supply switch on the rear panel to the “On” position.
What to do if my Infomir Set-top box has a defective audio cable?
Try using a different audio cable or a different connection method, referring to the connection guide if needed. Also, check to make sure the connection is secure.
How to change TV system settings on Infomir Set-top box?
Use a video output that supports HD modes, such as component Y-Pr-Pb or HDMI. Alternatively, set the TV System to an SD mode like «576i PAL» in the bootstrap loader menu.
User should not attempt self-repair; contact authorized service center for technical questions.
Avoid water and moisture to prevent ignition or electric shock; disconnect immediately if exposed.
Explanation of the bootstrap menu for software loading, settings, and navigation.
Steps to load basic software from internal flash memory using the bootstrap loader.
Steps to load basic software via the local network using DHCP.
Access to network configuration settings for the device.
Access to view and manage IPTV channels.
Method for simultaneous software upgrade for multiple devices via multicast.
Method for upgrading software using a USB storage device.
Method for upgrading via NFS, requiring tftp, nfs, and dhcp servers.
Identifies issues when the front panel red LED is off and suggests solutions.
Identifies issues when the red LED is on but no image is displayed.
General| Ethernet | 10/100 Mbps |
|---|---|
| USB | USB 2.0 |
| Wi-Fi | 802.11 b/g/n |
| Video codecs | H.264 |
| Audio codecs | AAC, MP3, AC3 |
| Audio output | S/PDIF |
| Power supply | 5V, 2A |
To Next Page
