Step 1
Connect HDMI Cable
Step 2
Connect Power Supply Unit
Step 3
Connect to the Internet
(via Ethernet or Wi-Fi
*)
Connecting to MAG520, MAG520w3
WARNING! SWITCH OFF ALL THE DEVICES (TV, AMPLIFIER, ETC.)
AND TAKE THE POWER SUPPLY UNIT OUT OF THE SOCKET BEFORE
CONNECTING OR DISCONNECTING ANY CABLE.
* ONLY IN MAG520W3
About your MAG520, MAG520w3
1. USB 2.0
2. USB 3.0
4. Fn – Reset to factory settings/ Load from the rst U-boot/
“Emergency” – Load the basic software from USB/DHCP
1. Power Supply 5V 2. HDMI 2.1 3. Ethernet LAN
port
Front Panel
Back Panel
To Next Page
Loading...
Need help?
General
