Need help?Do you have a question about the Infortrend EonStor GSe Pro 108 and is the answer not in the manual?
General| Model | EonStor GSe Pro 108 |
|---|---|
| Category | Storage |
| Type | NAS |
| Form Factor | 2U |
| Drive Bays | 8 |
| RAID Levels | 0, 1, 5, 6, 10, 50, 60, JBOD |
| Host Interface | 10GbE, 1GbE |
| Power Supply | Redundant |
| Power Supply Wattage | 500W |
| Supported Drives | 3.5" SATA HDD/SSD, 2.5" SATA HDD/SSD |
| Drive Interface | SATA 6Gb/s |
| Connectivity | iSCSI, NFS, CIFS/SMB |
| Protocol | iSCSI, NFS, AFP, FTP |
| Network Interfaces | Ethernet |
| Processor | Intel Xeon |
| Memory | 8GB DDR4 |
| Expansion Slots | 2 |
| Operating System | EonOne |
| Dimensions (H x W x D) | 88mm x 482mm |
| Weight | 15 kg |
Provides guidelines for setting up and operating the system safely.
Offers instructions for maintaining and servicing the system, including handling drive trays and cleaning.
Lists essential requirements before beginning the hardware installation process.
Outlines the step-by-step procedures for installing the system and its components.
Provides requirements and steps for installing hard drives into the system.
Guides on how to install a host or expansion board into the system.
Details how to connect the system to expansions, power, and the network.
Provides step-by-step instructions for replacing the system's memory modules.
Details the procedure for adding or replacing a host/expansion board.
Guides on how to identify and replace faulty hard drives.
To Next Page