Need help?Do you have a question about the Infortrend EonStor DS 1012 and is the answer not in the manual?
General| Model | EonStor DS 1012 |
|---|---|
| Category | Storage |
| Form Factor | 2U |
| Drive Bays | 12 |
| Supported RAID Levels | 0, 1, 5, 6, 10, 50, 60 |
| Max. Number of Volumes | 512 |
| Host Interfaces | 8Gb/s Fibre Channel, 1Gb/s iSCSI, 10Gb/s iSCSI, 6Gb/s SAS |
| Cooling | Redundant Cooling Fans |
| Power Supply | Redundant Power Supplies |
| Drive Type | SAS, SATA |
| Host Interface Speed | 8Gbps, 1Gbps, 10Gbps, 6Gbps |
| Controller | Dual active controller |
| Max. Number of Snapshots | 256 |
| Power Supply Wattage | 500W |
| Dimensions (H x W x D) | 88mm x 482mm x 650mm |
| Operating Temperature | 0°C to 40°C |
| Operating Humidity | 20% to 80% (non-condensing) |
Essential safety guidelines for installing and operating the system.
Procedures to prevent electrostatic discharge damage during handling.
Description of controller modules for RAID and JBOD systems.
Description of components found on the rear panel.
Conditions and requirements before starting hardware installation.
Steps for powering the system on and off safely.
Procedure for replacing single or dual controller modules.
Step-by-step guide for replacing a failed hard drive.
To Next Page