Need help?Do you have a question about the Infortrend EonStor DS 1000 Gen2 Series and is the answer not in the manual?
General| Model | EonStor DS 1000 Gen2 Series |
|---|---|
| Supported Protocols | iSCSI, Fibre Channel |
| Drive Types | SSD |
| RAID Levels | 0, 1, 5, 6, 10, 50, 60 |
| Number of Drive Bays | 12, 24 |
| Power Supply | Redundant power supply |
| Form Factor | 2U |
| Host Interface | Fibre Channel (FC), iSCSI, SAS |
| Maximum Raw Capacity | Up to 480TB |
| Controller | Dual active-active controllers |
Guidelines for installing and operating the storage system safely.
Essential information and recommendations for system service and maintenance.
Records changes and updates made to the manual over time.
Requirements and preparations needed before installing hardware components.
A step-by-step guide to the overall hardware installation process.
Instructions for unboxing and verifying all system components.
Detailed steps and prerequisites for installing hard disk drives.
Key factors and best practices for connecting the storage system.
Various configurations and layouts for connecting hosts to the storage system.
Recommended settings and configurations for host system parameters.
Configuration for managing simultaneous host-LUN connections.
Details on components used for Fibre Channel and iSCSI host connections.
Describes different connection topologies for Fibre Channel hosts.
Step-by-step instructions for connecting Fibre Channel cables.
Configuration for DAS with redundant host paths for increased reliability.
Describes switched fabric connection for single-controller models.
How to connect the storage system to two separate servers using DAS.
Overview of network and host connection topologies for iSCSI.
Setting up a single-controller system with fault-tolerant data paths.
Recommended cabling for IP SAN with remote replication setup.
Connecting a hybrid system to both Fibre Channel and iSCSI hosts.
Guidelines for configuring SAS expansion enclosures.
Rules for connecting SAS interfaces across storage and expansion enclosures.
Pre-power on checks for proper system setup and connections.
Instructions for connecting the system's power cords correctly.
Step-by-step guide to power on the storage system and related devices.
Verifying system status after powering on using LEDs and alarms.
Overview of features used to monitor system operation statuses.
Explains the status indicators on the front panel LED panel.
Details on the LED indicators for each individual drive tray.
Explains the status indicators for the controller modules.
Procedures for resetting the system to its factory default configurations.
Steps for replacing controller modules, including single, dual, or simultaneous upgrades.
Instructions for replacing the host board component of a controller.
Guide on how to replace or upgrade the DRAM modules in the storage system.
Procedures for replacing Cache Backup Module (CBM) components.
Indicators and methods to identify a failing Power Supply Unit (PSU).
Step-by-step guide to replace a faulty Power Supply Unit (PSU).
Detailed technical specifications for the storage system components.
Specifications related to the system's power supply unit.
Physical dimensions of the storage system in various series.
Environmental operating conditions and specifications for the system.
Information and guidance on installing slide rail kits for enclosures.
Essential prerequisites for installing enclosures using slide rails.
Instructions for unpacking the system components for slide rail installation.
The order of installing components when using slide rails.
Details on the accessories included with the rack ear mount kit.
Step-by-step guide for mounting the enclosure using rack ear mounts.
List of all accessories included with the slide rail kit.
Important safety precautions to follow after the enclosure has been mounted.
To Next Page