Need help?Do you have a question about the Infortrend EonStor DS 1012 Gen2 and is the answer not in the manual?
General| Model | EonStor DS 1012 Gen2 |
|---|---|
| Category | Storage |
| Form Factor | 2U |
| Drive Bays | 12 |
| RAID Levels | 0, 1, 3, 5, 6, 10, 30, 50, 60 |
| Cooling | Hot-swappable fans |
| Supported Drives | SAS, SATA, SSD |
| Host Interfaces | iSCSI, Fibre Channel, SAS |
| Operating System Compatibility | Windows, Linux, VMware |
| Cache Memory | Up to 16GB |
| Processor | Intel Xeon |
| Dimensions (H x W x D) | 88 mm (3.5 in) x 446 mm (17.6 in) x 500 mm (19.7 in) |
Guidelines for safe installation and operation of the storage system and expansion enclosures.
Lists requirements and preparations before installing hardware components.
Provides a step-by-step overview of the hardware installation process.
Step-by-step guide for installing hard drives into the system.
Instructions for installing the CBM into the controller.
Instructions for installing Super Capacitor and Flash Backup Module.
Key factors to consider when making system connections.
Guide on using hybrid iSCSI ports for remote data replication.
Details the configuration of SAS expansion enclosures.
Checklist of items to verify before powering on the system.
Steps for connecting the system's power cords.
Step-by-step guide for powering on the storage system.
Verifying system status after powering on using LEDs and alarms.
Step-by-step guide for safely powering down the storage system.
Lists the system components that can be replaced.
Instructions for replacing controller modules (single/dual/simultaneous).
Guide for replacing the controller's host board.
Instructions for replacing DRAM modules on storage system controllers.
Guide for replacing the Cache Backup Module (CBM).
Steps for replacing the Battery Backup Unit (BBU).
Instructions for replacing the Flash Backup Module (FBM).
Guide for replacing Super Capacitor and Flash Backup Module.
Step-by-step guide for replacing a hard drive in the system.
To Next Page