Infortrend EonStor DS 1012 Gen2 - Power On Status Check

94
Power On Status Check
As a general rule, once the system has been powered on, there should NOT be
LED(s) that light up amber nor should you hear an audible alarm from the system.
You should begin verifying system statuses via the following monitoring interfaces:
 LEDs on rear chassis, including controller module, PSUs, and cooling
modules (refer to System Monitoring).
Controller LEDs:
1.
Ctrl Status LED: On (green)
4.
CBM Status LED: On (green) or
Off (if not installed)
2.
C_Dirty LED: Off
5.
Hst Bsy LED: On (green)
3.
Temp LED: Off
6.
Drv Bsy LED: On (green)
PSU & Cooling Module LEDs:
PSU LED: On (green)