Ingco AC1200508 - Operation of the Compressor; Maintenance

Operation of the compressor
The compressor uses an air switch to control the motor . When the pressure in the
air storage tank rises to the rated maximum pressurethe air switch automatically breaks
to disconnect the power and stop the air compressor . e n the pressure in the air
storage tank goes down below the rated minimum pressurethe air switch automatic all y
oses and restarts the motor to dirve the co mpressor.
Adjust the exhausting air pressure
a.pull out upward the knob of the pressure adjuster turn clockwise to increase
the
exhausting air pressure to a rated maximum pressure the same as in the air storage
tank (Figure 4)
b.pull out upward the knob of the pressure
adjuster turn anticlockwise to reduce the
exhausting air pressure to zero bar.
Caution:
(l) en adjusting the exhausting air pressure you can look into the small manometer
to get the pressure reading.
(2) en the manometer shows the mamum pressure v u es, stop turning clockwise.or
the thin ftlm of the pressure adjuster would be
damaged.
(3)When the compressor stop working turn the pressure adjust anticlockwist to
zero bar and then stop , you may open the drain tap to make sure that e compressor
stops.
Maintenance
a. en the new machine has been set to work for 50 hours, unscrew the oil es-
cape-bolt to let out the old lube and add in the new
lube to the marked level of the dipstic
b.Clean the filter every 100 hours.(Figure 5)
c.Replace the ftlter element with a new one if it is too dirty.
d.Turn one water escape v ve at the botton of the air storage tank to drain everyday.
e In every 500 hours or 12 months replace the lube with new lube
.
f.Please check the sensitivity of the safety v v e and the operating p once a wee
G.Check the tightness of the V-belt once in three months.
5|English