Copyright© 2021 Ingenico
All rights reserved
12
Self/8000 Quick start
900045144 R11 000 04/0221
First of all, unplug all the wires from the terminal.
Cleaning of the terminal
Zunächst entfernen Sie alle Kabel vom Terminal.
Reinigung des Terminals
Avant cette opération, débrancher tous les câbles du terminal.
Nettoyage du terminal
Good rules for proper cleaning of the terminal are :
Use a soft cloth that is very slightly soaked with soapy water
to clean the outside of the terminal.
Do not clean the electrical connections.
Do not use in any case, solvents, detergents or abrasive
products : Those materials might damage the plastic or
electrical contacts.
Avoid exposing the terminal to the direct rays of the sun.
Regeln zur Reinigung des Terminals :
Verwenden Sie zur Reinigung des Äußeren des Terminals ein
weiches Tuch, das leicht in Seifenwasser getaucht wurde.
Die elektrischen Anschlüsse dürfen nicht gereinigt werden.
Auf keinen Fall dürfen Lösungsmittel, Waschmittel oder
Scheuermittel verwendet werden : diese könnten die
Kunststoffteile oder Kontakte beschädigen.
Der Terminal sollte keiner direkten Sonnenbestrahlung
ausgesetzt werden.
Avant toute opération de maintenance du terminal, s’assurer que
l’alimentation électrique est déconnectée.
ATTENTION
3_Maintenance
Before making any operations of maintenance in the terminal, make
sure that power supply is disconnected.
ATTENTION
Stellen Sie vor der Durchführung von Wartungsarbeiten am Terminal
sicher, dass die Stromzufuhr abgeschaltet ist.
ACHTUNG