Ingenico iCMP - Credit Signature Payment Flow; Select Payment Type; Insert, Swipe, or Tap Card; Confirm Amount and Add Tip

Ingenico iCMP wireless EMV Reader: Tech Guide
Document Revision: v1.1.2
of
1 7
This tech guide should be followed in the event your Ingenico iCMP Wireless EMV
reader fails to connect to the Washlink Systems Voyager Saleslink terminal.
Follow this guide’s steps in order. If the current step fails, proceed to the next step. If
it succeeds, you may stop reading and carry on with processing transactions as
normal.
If you reach the end of this guide and still the iCMP will not connect, contact Washlink
Systems support; +1-408-924-0808, support@washlinksystems.com
This tech guide should be followed in the event your Ingenico iCMP Wireless EMV
reader fails to connect to the Washlink Systems Voyager Saleslink terminal.
Follow this guide’s steps in order. If the current step fails, proceed to the next step. If
it succeeds, you may stop reading and carry on with processing transactions as
normal.
If you reach the end of this guide and still the iCMP will not connect, contact Washlink
Systems support; +1-408-924-0808, support@washlinksystems.com
• The image above is what the iCMP will show when connected and in standby
mode. Note: this message may vary depending on your configuration.
• The iCMP connects to the Voyager terminal using Bluetooth
• Out of the box and after fully booted, the iCMP’s default message shows
“LISTENING FOR INPUT”. This text can be changed via the RCM software.
• The image above is what the iCMP will show when connected and in standby
mode. Note: this message may vary depending on your configuration.
• The iCMP connects to the Voyager terminal using Bluetooth
• Out of the box and after fully booted, the iCMP’s default message shows
“LISTENING FOR INPUT”. This text can be changed via the RCM software.