Ingenico Link/2500 Connecting Guide

Connecting Link 2500 to Wi-Fi
These are the steps involved in connecting a Link/2500 chip reader
to a Wi-Fi network.
• If the Link/2500 should power itself on when plugged into a
power source. However, if it is powered down, press the
green button to power on the device:
• To access the admin menu, quickly press the following
buttons on the pin pad: 2, 6, 3, 4.

Ingenico Link/2500 Specifications

General

Memory	128MB Flash
Display	320 x 240 pixels
Connectivity	USB
Card Readers	Magnetic stripe
Certifications	EMV Level 1 & 2
Payment Methods	Contactless