18 03539319_ed3
Cranks
Ok
Cranks
Ok
Cranks
Ok
Valve operates properly
Starter will not stop operating or
Starter cuts out too soon
Check system wiring
Refer to Pg. 7 Dwg. TPB973-1
Malfunctioning Valve - Drain air from reservoir rst by removing 1/4” plug on starter
valve opposite tank ll. Loosen cap on Bottom of valve. Inspect plunger for damage
and/or proper lubrication. Lubricate or replace the plunger if necessary. Measure
resistance of solenoid coils. Resistance should be approximately 30 ohms. Replace
solenoid coils if necessary.
* Refer to Page 14-15 for valve maintenance.
Check system oil pressure
lockout switch (Terminal 150).
If malfunctioning: replace
To Previous Page
Loading...
