10
Figure 4-1 Ethernet Connection
Step 2:
Set the PC in the same network segment as the ip address of gateway device.
Method 1: DHCP automatically get the address (Recommended)
Method 2: Use fixed IP address, set the PC and gateway in the same address segment
(DHCP Server for LAN2 Port is default enabled)
Figure 4-1-2 Dynamic acquisition/manual Configuration
PC only needs to configure the IP address to any value in:
“192.168.2.2.2~192.168.2.254”
The gateway is set to: “192.168.2.1”, the subnet mask is: “255.255.255.0”
The DNS is configured to “operator DNS server address”.
To Next Page
Loading...
