Inhep Digital Security IDS 400 - Zone reporting codes; Open reporting code; Close reporting code

28 IDS400 INSTALLER MANUAL NO. 700-204-02A ISSUED NOV 2000 VER 1.01
IDS400 INSTALLER MANUAL
78-08SNOITACOLsedocgnitroperenoZ
-
oitacoL
n
edocgnitropeR
18-081enoZ
38-282enoZ
58-483enoZ
78-684enoZ
88NOITACOLedocgnitropernepO
The open code will be reported when the system is disarmed.
NOTE:
The digit programmed into this location is the first digit of the reporting
code. The second digit will automatically be added and will be the
number which corresponds to the user code used to disarm the
system (see Users Manual).
EXAMPLE:
If an open code of [B] (11) is programmed and the master user code is
used to disarm the system, the 2 digit reporting code would be “B1”
indicating an open by user 1.
NOTE:
If the system is disarmed by means of a key-switch or remote control
unit using an arm/disarm zone the system will report open by user 2.
98NOITACOL devreseR
09NOITACOLedocgnitroperesolC
The close code will be reported when the system is armed in the away
mode indicated by illuminated ARMED and AWAY LED’s on the
keypad. As for the open reporting code this is a single digit code with
a second digit added from the relevant user code.