Configuration manual
Parameters of devices and their groupings 25
The parameters available for programming the group are:
• Description of the group
• Delay (sec), duration of the delay (in seconds) before
activation of the outputs belonging to the group after the
activation of the group itself
• Pulse, option that determines that pulse signals will
activate the group of outputs (once the group has been
activated, the outputs associated with it will remain active
for the specified time and then return to the stand-by
status).
If activated, you must specify the duration of the pulse
activation signal (in the box at the bottom)
4.5 Replicate programming procedure
The Previdia Compact control panel allows you to copy the
programming of a single element (point, zone, group) and
replicate it on other elements in its category and group.
Accessing the screen of the group of elements undergoing
programming (in index order) and selecting one of them
enables the Program button to modify the parameters, and
the Copy on… button to copy the programming.
The Copy on... button opens a window that provides three
options:
• Single item, if activated, the programming will be
replicated on the element with the index indicated in the
box next to it.
• Range, if activated the programming will be replicated on
the elements whose indexes belong to the interval
indicated in the boxes at the side.
• All, if activated the programming will be replicated in all
the elements of the same group of which the selected
element is part
Following the selection of one of these options and after pressing the Set button, all copied settings, except the
description, will be applied to the programming of the desired elements.
To Next Page
Loading...
