Do you have a question about the Inkbird IHC-200 and is the answer not in the manual?
Humidity Accuracy | ±3%RH |
---|---|
Humidity Resolution | 0.1%RH |
Display | LCD |
Protection Level | IP20 |
Power Supply | 100~230Vac, 50/60Hz |
Alarm | Yes |
Temperature Resolution | 0.1°C |
Relay Capacity | 10A/250Vac |
Humidity Control Range | 0% to 99% RH |
Press and hold SET for 3s to enter setting mode, use keys to change values, press and hold SET for 3s to save.
Explains how HS, HD, and DD parameters control humidification and dehumidification based on measured humidity.
Describes how AH and AL parameters trigger alarms when measured humidity exceeds set limits.
Details the PT parameter, which provides a delay before starting dehumidification to protect the compressor.
Details sensor fault mode: buzzer alarm, ER display, and actions to resolve the issue.