The following curve depicts the Output Power vs. Range of Load Impedance.
The device has been tested and found to comply with the limits for the medical devices to
the IEC 60601-1-2. These limits are designed to provide reasonable protection against
harmful interference in a typical clinical installation. This device generates uses and can
radiate radio frequency energy. If not installed and used in accordance with the
instructions, may cause harmful interference to other devices in the vicinity. However,
there is no guarantee that the interference to other devices, which can be determined by
turning the device off and on, is caused by this instrument.
The user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving device.
Increase the separation between the devices.
Connect the device into an outlet on a circuit different from that which was
previously used.
Consult InMode MD Ltd. service personnel for help.
0.00
5.00
10.00
15.00
20.00
25.00
30.00
35.00
40.00
0 50 100 150 200 250 300 350 400 450 500 550 600 650 700 750 800 850 900
Output Power [W]
Load [Ohm]
IRF Output Power vs. Impedance
To Next Page
Loading...
