CONTOURA Operator Manual 7
Section 2 – Safety
This chapter describes safety issues regarding the use and maintenance of the System,
with a special emphasis on electrical safety.
The System is designed for safe and reliable treatment when used in accordance with
proper operation and maintenance procedures. Only trained, qualified practitioners can
use the System. The operator and all other personnel operating or maintaining the System
should be familiar with the safety information provided in this Section.
The primary consideration should be to maximize safety for both treating attendant and
patient.
Read this chapter to be familiar with all its safety requirements
and operating procedures prior to System operation.
RF energy can cause injury if used improperly.
High voltage is present inside the System.
Always be aware of the possible dangers and take proper
safeguards as described in the manual.
The Patient
Well-trained staff is a key for assuring patient safety. A patient history should be
completed prior to scheduling. Patients should be fully informed of the treatment
protocol, the likely results, and any risks associated with the treatment.
Patients should not be in contact with any metal or other alternate pathway to the ground
while system is in use.
Metal jewelry and metal accessories that are within the activation range of the Handpiece
should be removed to avoid accidental RF conduction.
Treating Attendant
Only authorized individuals with appropriate laser training and knowledge should
operate, assist in the operation of, or provide maintenance to the System.
Personnel should not operate the System until they have been fully educated in its use.
Make sure that all treatment personnel are familiar with the System controls and know
how to shut down the System instantly.
There are no user-serviceable parts in the system, and all service and repair must be
performed only by the factory or authorized field service technicians.
To Next Page
Loading...
