To avoid personal injury, please follow the instructions shown in the diagram for assembly operation and inspection.
Children are not allowed to involve in assembly operations.
NOTE: Use the M6 wrench to re-tight the folding part's nuts in case it's loosen after long time use.
(No need to tight it during assembling since it has been firmly installed)
5. Assembling Your E-Scooter
07
R
L
5
6
2. Unfold the stem and fasten the folding wrench. Make sure
the unlocking key springs up normally after fastening. Be sure
to buckle up properly.
4. Install the handles on the stem and firmly tighten it
according to the correct position and direction marked on
the label.
M5 Wrench
M6 Wrench
4
3
1. Open the package, take out the inner tray and scooter.
3. Place the brake lever on the handlebar, tighten it firmly with
hex wrench to be sure it won't loosen.
To Next Page
Loading...
