4.3 How beginner gets started?
Hold the handlebar with two hands, slide the scooter to power on.
After powered on, the front decorative lights and taillights will be lighted on.
Step on the footboard with one foot, watch ahead, another foot shall be on the ground and slide forwardly, to give the scooter an initial velocity. Once the
speed control is activated, the scooter could be accelerated to move forwardly by press the key of the throttle.
At that time, another foot also steps on the footboard. Two feet stand in staggered way front and back. Stands upright naturally and two eyes watch ahead
horizontally, like standing on the ground. Keep the balance of the body.
Lightly press the accelerator key for acceleration. The degree of acceleration depends on holding a degree on the accelerator. Beginners shall lightly hold the
accelerator key and accelerate slowly.
Due to the length of L8, do NOT make a turn in the narrow space.
On riding, press the brake key to decelerate the scooter or stop it.
At the same time, stepping on the rear fender by one foot, the scooter could be slowed down or stop.
Press brake key, the accelerator will become invalid automatically.
If the scooter has no operation within 1 minutes, the scooter will be automatically shut down.
4.4 How to fold the scooter?
1.Open the Quick-release wrench,
2.One hand holds the Front-rod and the other hand holds the Square-tube. Push forward the Front-rod and Press down the Folding-wrench. Then pull back
the Front-rod after pressing the Folding-wrench
3.Fold down the Front-rod until it gets stuck.
The brake performance may be affected by moisture. After Cleaning the body, dry the brake at a safe place by air.
*Scooter is not allowed to ride under severe weather conditions (like raining, snowing or icy).
* Make sure the brake work normally Before riding the scooter under any circumstance.
WARNINGS!
11
To Next Page
Loading...
Need help?
General
