InMotion RS - ASSEMBLY

10
Open the package:
Take out the 6 connecting buckles and lift the outer
box upwards, revealing the inner packaging and
scooter, and take out the accessory box.
Install the handlebar and front headlight assembly:
Take out four M6*30 cylindrical head screws and
one M8*16 hexagonal socket screw, tighten them
in the corresponding positions according to the
diagram.
Install the rear mudguard:
Take out four M4*10 cylindrical head screws and
one M4*8 round head hexagonal screw, tighten
them in the corresponding positions according to
the diagram.
Connect the waterproof wire:
Connect the corresponding lines according to the
color and follow the directional arrows. (Power
switch key, dashboard, throttle, brake, turn signal,
headlight waterproof wire)
Hold the handlebars and unfold the folding stem:
Adjust the height of the stem according to the
scale and lock the stem clamp.
Fasten the folding wrench:
Fasten the folding wrench according to the
diagram, turn the screw by hand to fix the safety
buckle.
waterproof wire
Screw
Folding wrench
Safety buckle
ASSEMBLY
Accessory box