Innodisk EMP2 SERIES - Configure Serial Modes via Hardware DIP Switches; Enable RS-485 Half Duplex Mode in Windows

6
2005-2017 © Innodisk Corporation. All Rights Reserved
1.3. Switch Mode by Hardware (for EMP2-X202/X402)
This section is applicable to following products
Product No.
RS232
RS485HD
RS485FD
Switch Method
EMP2-X202
X
O
O
Hardware
EMP2-X402
X
O
O
Hardware
Switch mode between RS485 Half Duplex and Full Duplex by using DIP switch.
Please refer to the following picture:
1.4. Enable RS-485 checkbox for RS-485 Half Duplex Mode
This section is applicable to ALL products.
In Device Manager, right click the mouse to enter “properties” in “Innodisk’s
Communications Port (COM“N”)”. (“N” depends on the setting of real
environment.)
In “Port Settings”, please check RS-485 checkbox when using RS-485 Half
Duplex Mode