Innodisk EMP2 SERIES - Apply Hardware DIP Switch Settings in Linux

9
2005-2017 © Innodisk Corporation. All Rights Reserved
 COMMAND: emp2init reset
Reset all port to default mode RS232.
2.4. Switch Mode by Hardware (for EMP2-X202/X402)
Please follow instructions in 1.3. Switch Mode by Hardware to configure DIP
switch.
This section is applicable to following products.
Product No.
RS232
RS485HD
RS485FD
Switch Method
EMP2-X202
X
O
O
Hardware
EMP2-X402
X
O
O
Hardware
After changing DIP switch between RS485HD and RS485FD, you need to
execute the command “emp2init reset” to take effect, then you can also check
the configuration file (/etc/emp2.cfg) to make sure it is in the correct mode.
Notice, all EMP2 control tools need to be executed as root.