YOUR DEVICE
� Mesh Coil – latest Technology
� Draw activated – simply inhale as you would a cigarette
� Rubber Seal protected tank, reduces chance of leakage
� 2ml capacity – clear tank to see liquid level
� 650mAh battery – charges to 75% within 30 mins
CHARGING
GETTING STARTED WITH YOUR DEVICE
Filling the Pod with E Liquid
• Detach the rubber seal on the side of the tank and add the e-liquid. Please avoid over filing.
• Once filed, ensure the rubber seal is attached securely back with the tank.
This is very important to avoid any leakage of the e-liquid from the tank.
• Firstly, take two strong inhales/puffs with the POD still detached from the battery to pull the liquid into the cotton.
• Allow 10 minutes for the liquid to fully soak the coil before beginning to vape.
Starting to Vape
• Switch on your device by pressing the button 3 times in quick succession.
• Start with a few short inhales to test the pod, then begin to use as normal.
• Remember to keep liquid topped up to prevent drying out the coil too soon.
Nicotine Strengths Available:
20mg / 10mg / 5mg
Your starting nicotine strength has been selected for you based on your tobacco use. Should you need to, you will be able to select an
alternative strength for the remainder of the program. However, don’t feel the need to reduce too early.
It’s important to use the right combination of e-liquid and e-cig to manage nicotine cravings, and to use them as much as you need to. The
best benefits from vaping are seen when users stop smoking cigarettes completely.
Vaping as a quit smoking aid is most effective when combined with expert support, so it is important to regularly engage with your advisor.
Dinner Lady E-liquids are regulated under UK Standards, ensuring you receive high quality products.
Nicotine Salts provide fast blood absorption and are smoother to inhale.
STEP 1 Detach the rubber
seal.
STEP 2 Fill the POD with
e-liquid.
STEP 3 Re-attach the rubber
seal securely. Leave 10
minutes to soak.
POWER
Turning On/ Off
• To power the device on or off, press the button on the side 3 times quickly.
The LEDs on the side of the device will flash to show power on or off.
• The device is draw activated which means there is no need to press any
button on the device when inhaling.
• Remember to power off the battery when it is not being used.
Note: after charging the device,
please ensure it is switched on before use.
Please use the provided cable for charging
FLAVOURS AVAILABLE:
If you would like to purchase additional supplies, please see the full range by visiting
www.vapedinnerlady.com where you can receive a discount by entering the following code at checkout:
SMOKEFREE20
Charging the Battery
• Plug the USB-C end of your charging cable into the charging slot on the bottom of
your device and plug the other end into a USB charging port.
• The device is compatible with most USB ports found commonly on mobile phone
plugs, laptops, and games consoles etc.
• An LED around the bottom of the device will flash slowly to indicate the device is being
charged. It takes around 30 minutes for the battery to charge 75%.
• Once the device is fully charged this will be indicated with a solid light around the base
of the device.
Remove the charger from the battery when complete.
Remember to not leave the battery unattended and do not charge overnight.
SMOOTH
TOBACCO
SPEARMINT
MENTHOL
STRAWBERRY
WATERMELON
KIWI PASSION
GUAVA
CHERRY
BLAST
BLUEBERRY
LEMONADE
STEP 4 Insert POD into device
(Only goes in one way).
Please Scan the QR
code to view a video
guide to set up your
new device
Please Scan the QR code to view a video
guide to set up your new device
When vaping, the number of LEDs
illuminated display the remaining
battery charge:
• 3 lit: Over 65%,
• 2 lit: 15-65%
• 1 lit: Less than 15%.
You can also press the button to
view battery level when not vaping.
The LED’s will turn off when fully
charged.
To Next Page
Loading...
